Powerplus POWX0910 Manual descarregar pdf (Página 8)

POWX0910 EN

the cutting machine is in operation. The outlet must project out of the rear

of the machine. Two bolts and nuts are supplied to attach it.

 Hold the dust extraction outlet (14) in position and lay the cutting machine on its side.

 Push the screw through the hole of the template guide (a), dust extraction outlet (14) and

router’s base plate (8) and until it projects at the fastening point for the dust extraction

outlet.

 Tighten the screw with a suitable screwdriver and moderate force until the outlet is

securely attached.

 Repeat the procedure at the other side.

CAUTION: Dust may cause respiratory problems. Certain laminated board

materials are carcinogenic. After work, always remove all dust from the

machine.

7.7 Using the dust exhaust connection

 The dust exhaustion outlet (14) shall be connecting together with an external vacuum

cleaner to take away the dust in dust cover.

 If necessary, place an adapter on the dust exhaust.

8 OPERATION

8.1 Cutting in several operations (Fig. 7)

The length-stop turret (9) can be used to set different depths.

For cutting in depth and in stages, use the length-stop turret (9) as an aid. Using the depth

stop set the desired depth to the lowest depth-stop position on the turret. Rotate the turret so

that the highest point is under the depth stop and execute the first cut. Repeat the cut with the

second-highest setting and finally with the last setting. You can also use two positions if the

desired depth is reached in two operations.

8.2 Switching on and off (Fig. 8-9)

 Connect the plug to the power supply.

 To switching the tool on, keep the lock-off button (12) depressed and press the ON/OFF

switch trigger (11).

 To switching the tool off, release the ON/OFF switch trigger (11).

 To adjust the cutting speed, turn the speed control dial (2). Position “1” denotes the lowest

speed. Position “7” denotes the highest speed. Turn the knob to increase or decrease the

speed. The smaller the cutter head, the higher the speed. The larger the cutter head, the

lower the speed. A cutter head which runs too fast causes scorching of the work-piece and

leaves burnt marks.

CAUTION: Do not change the speed when the machine is working under

load.

8.3 Cutting direction

 Always observe the safety instructions and applicable regulations.

 Always move your router as indicated in below Fig. 10 (outer edges/inner edges).

 To prevent the cutter head from jumping and to obtain a good result, carry out exterior

cuts in anticlockwise and interior cuts in clockwise direction.

NOTE: Check that the cutter is correctly installed in the collet.

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Powerplus POWX0910 Manual Página 8